Product Description
70499 4" to 2-1/2" Steel Ring Port Receiver — Magnetic Dust Collection at Every Machine Port
Moving a dust collector hose from machine to machine is one of those shop chores that should take two seconds — and with the right fittings, it does. The POWERTEC 70499 Steel Ring Port Receiver creates a dedicated magnetic docking point at any 2-1/2" machine port, allowing POWERTEC magnetic dust collection connectors to snap on and release instantly without threading, clamping, or wrestling with a loose hose. One receiver installs once. After that, connecting your 4" magnetic dust collection hose to that port takes exactly as long as it sounds — one snap, and you're cutting clean.
The 70499 is the piece that makes a one-hose shop actually work. Install receivers at your table saw, planer, jointer, band saw, or sander, and your single dust collector hose becomes a quick-connect system that follows you to every machine without permanent ducting, blast gate headaches, or extra hose runs eating up floor space. Built with a zinc-plated steel ring for corrosion resistance and an impact-resistant ABS housing, this receiver is engineered for the daily connect-disconnect cycle of an active shop. Note: flex cuffs for dust port connections are sold separately.
Key Features & Benefits
Magnetic Docking Point for 2-1/2" Machine Ports
- Creates a secure magnetic interface at standard 2-1/2" dust ports, allowing POWERTEC magnetic connectors to snap on and release without tools, clamps, or tape — making hose moves between machines a one-handed, one-second operation.
- Maintains a reliable 4" dust collection interface at the hose side while adapting down to the 2-1/2" machine port, bridging the most common size mismatch in mixed shop dust collection setups.
One-Hose Multi-Machine Dust Collection
- Install receivers at every machine port in your shop and run a single dust collector hose across all of them — eliminating the cost, complexity, and floor-space penalty of permanent multi-drop ducting in smaller or flexible shop layouts.
- Streamlines workflow on busy shop days — move from the table saw to the planer to the jointer without stopping to swap hose adapters, fight friction-fit connections, or drag a second machine into position near a fixed port.
Compatible with 2-1/2" Machine Dust Ports
- Fits the 2-1/2" dust ports found on table saws, planers, jointers, band saws, sanders, and benchtop tools — covering the full range of machines most commonly used in a woodworking or general shop environment.
- Pairs with the broader POWERTEC magnetic dust collection system for a fully connected, quick-release shop setup that scales as your tool collection grows.
Zinc-Plated Steel Ring & ABS Housing — Built for Daily Shop Use
- The zinc-plated steel ring resists corrosion from the moisture and humidity common in working shop environments, maintaining a clean magnetic mating surface through years of daily connect-disconnect use.
- Impact-resistant ABS housing handles the incidental knocks and bumps of jobsite and shop use without cracking or deforming — keeping the receiver seated and the magnetic interface intact.
Expand Your Magnetic Dust Collection System — One Port at a Time
- Add receivers to machines as you acquire them — the POWERTEC magnetic dust collection system grows with your shop without requiring a full system overhaul or new hose runs every time a new tool enters the lineup.
- Single-pack format lets you add coverage exactly where you need it, whether you're outfitting a new machine, replacing a worn receiver, or completing a shop-wide magnetic dust collection installation one tool at a time. Flex cuffs sold separately.
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
