Product Description
70501 4" Steel Ring Port Receiver — The Magnetic Dock Your Full-Size Dust Ports Have Been Missing
Full-size 4" dust ports on cabinet saws, large planers, jointers, and dedicated dust collectors move serious air volume — and they deserve a connection method that matches. The POWERTEC 70501 Steel Ring Port Receiver installs at any standard 4" machine dust port and creates a permanent magnetic docking point that accepts POWERTEC magnetic connectors with a single snap. No clamps. No tape. No friction-fit wrestling. Just a clean, airtight 4" interface that connects and releases in one motion every time you move your hose.
The 70501 is the 4" port answer to the same problem the 70499 solves at 2-1/2" — giving your full-size machines the same quick-connect magnetic capability as your smaller tools. Install a receiver at every 4" port in your shop and your dust collector hose becomes a fast-move system that follows you machine to machine without permanent ducting, blast gate runs, or secondary hose drops. Built with a zinc-plated steel ring for lasting corrosion resistance and an impact-resistant ABS body, the 70501 handles the daily connect-disconnect cycle of an active shop without loosening, wearing out, or losing magnetic mating performance. Note: flex cuffs for dust port connections are sold separately.
Key Features & Benefits
4" Magnetic Docking Point — Full-Size Port, Instant Hose Connection
- Creates a dedicated magnetic interface at standard 4" machine dust ports, allowing POWERTEC magnetic connectors to snap on and release cleanly without tools, clamps, or adapters — maintaining full 4" airflow diameter throughout the connection.
- Delivers a consistent, repeatable magnetic mating surface at every 4" machine port in your shop — once installed, every hose connection to that port takes one second, one-handed.
- Ideal for cabinet table saws, large benchtop planers, jointers, wide belt sanders, and dedicated dust collector inlets where full 4" port diameter and reliable airflow are essential.
One-Hose Multi-Machine System — Skip the Permanent Ducting
- Install receivers at every 4" machine port and run a single dust collector hose across your entire shop without permanent ductwork, blast gate hardware, or secondary drops consuming floor space and shop budget.
- Moves your workflow instead of anchoring it — connect at the machine you're running, release when you're done, and dock at the next one without slowing down between operations.
Zinc-Plated Steel Ring — Corrosion-Resistant Magnetic Mating Surface
- The zinc-plated steel ring provides a hard, wear-resistant mating surface that maintains precise magnetic alignment and a consistent seal through years of daily connect-disconnect cycles in a working shop environment.
- Zinc plating resists the surface corrosion and oxidation that degrades magnetic performance over time in shops exposed to humidity, moisture, or seasonal temperature swings.
ABS Housing — Impact-Resistant, Shop-Ready
- Impact-resistant ABS body handles incidental knocks and drops without cracking or deforming — keeping the receiver seated at the port and the steel ring face clean and undamaged.
- Lightweight construction adds no meaningful bulk to the machine port, keeping your dust collection setup clean and unobtrusive even on machines with limited port clearance.
Expand Your Magnetic Dust Collection System — One 4" Machine at a Time
- Add coverage to your full-size machines incrementally — the POWERTEC magnetic dust collection system scales to every 4" port in your shop without a full system overhaul every time a new machine joins the lineup.
- Pairs with the POWERTEC 70500 Magnetic Connector on the hose side and the 70504 Magnetic Dust Collection Fittings Kit for a complete quick-connect system. Flex cuffs sold separately.
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
