Product Description
14" Cold Saw Blade — 66 Teeth for Thin Stock, Cleaner Edges
Thin metal and mild steel punish a low-tooth-count blade — you get chatter, burr, and an edge that needs a pass on the grinder before it's usable. The POWERTEC 14014 puts 66 Triple Chip Grind (TCG) cemented carbide teeth on the blade, so each tooth takes a smaller bite and leaves a smoother edge behind, with less burr to clean up after.
Built for the same 14" cold saws and low-RPM chop saws as the rest of the POWERTEC blade line, running on a 1" arbor up to 1,600 RPM. This is the tooth count to reach for on tubing, conduit, angle iron, channel, and aluminum extrusions — thinner-wall stock where a coarser blade leaves too rough an edge. Not rated for galvanized, hardened, or high-carbon steel — for that, step up to a lower tooth-count blade built for heavier material removal.
Key Features & Benefits
Cemented Carbide Teeth
- Carbide bonded with a metallic binder gives each tooth industrial-grade wear and heat resistance
- Holds a consistent edge through repeated cuts instead of dulling fast on fabrication-shop volume
66-Tooth Design for Mild Steel & Thin Metal
- Higher tooth count means each tooth removes less material per pass, cutting vibration and chatter on thin-wall stock
- Delivers a smoother finish with less force required — easier control on tubing and thin extrusions
Triple Chip Grind (TCG) Tooth Geometry
- Alternating trapezoidal and flat-top raker teeth spread cutting force evenly across the edge
- Reduces chipping and tooth wear while keeping the cut clean on both metal and aluminum
Reduced-Spark, Low-Heat Cutting
- Low-RPM cold cutting throws far fewer sparks than an abrasive cutoff wheel
- Laser-cut stabilizer vents pull heat off the blade body, cutting down on warp and keeping cuts quieter
Non-Stick Coating & Saw Compatibility
- Teflon-based coating fights gumming and friction, especially on aluminum
- Fits 14" cold saws and chop saws with a 1" arbor — confirm your saw's max RPM is at or below this blade's 1,600 RPM rating before mounting
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
